How to convert PDF/raster image to vector and set vector size

The utility VeryDOC Raster to Vector Converter Command Line helps you convert PDF/raster to vector image and edit vector image size instantly and exactly. 🙂

You can find more useful information at homepage of this software from link above. And to know exact steps to use this application to convert raster image to vector image or convert PDF to vector and edit vector image size, please focus on following paragraphs here.

Well, please download trial version of VeryDOC Raster to Vector Converter Command Line here:

Download VeryDOC Raster to Vector Converter Command Line

After trial version belongs to you, maybe you need to read the followings, if you do want to know how to fulfill this process through command line:

Step1. Run command prompt window

You need to open operating environment of commands for Windows platforms through running cmd.exe in your computer, and finally, you can see there is window popping on screen, which is right command prompt window for typing commands later.

Step2. Convert raster/PDF to vector image and set vector image size

Here you can firstly understand following examples, then imitate them separately to accomplish your own conversion:

Raster2Vector.exe -width 595pt -height 842pt C:\in.png C:\out.eps

Raster2Vector.exe -pagesize a4 C:\in.pdf C:\out.emf

And here are explanation of examples above:

  • Raster2Vector.exe: call executive file “Raster2Vector.exe” for using application
  • C:\in.png/pdf: specify input raster image file or PDF file separately
  • C:\out.eps/emf: specify output vector image file of EPS or EMF separately
  • -pagesize <string>: set page size (default is letter)
  • -width <string>: set width of output file, unit: in/cm/pt
  • -height <string>: set height of output file, unit: in/cm/pt

After you convert raster image or PDF to vector image and edit vector image size through commands and two kinds of parameters separately, please check your destination folder, where vector image file with specific vector image size can be located. 🙂

This is the end of how to use VeryDOC Raster to Vector Converter Command Line to convert PDF/raster image to vector image and edit vector image size in Windows platforms. For your concerns about this application and this article, welcome to add your comment here. And for full version of this utility, here is quick entrance for getting it online:

Purchase VeryDOC Raster to Vector Converter Command Line

VN:F [1.9.20_1166]
Rating: 0.0/10 (0 votes cast)
VN:F [1.9.20_1166]
Rating: 0 (from 0 votes)

Related Posts

This entry was posted in Raster to Vector Converter and tagged , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *


Verify Code   If you cannot see the CheckCode image,please refresh the page again!